4-3
Section
ID Tag
59
Mount the V700-D
j
3P41(-Y) ID Tags as shown in the following diagram to en-
sure the maximum communications distance. The communications distance will
drop about 10 mm if the Tag is installed backwards.
Antenna
Mounting Example (Attaching the ID Tag with Adhesive)
Refer to the following diagram for mounting-hole dimensions. There is a danger
of damaging the ID Tag by pressing it into place, so we recommend mounting the
ID Tag with adhesive.
Non-metal
material
+0.1
45.0
25.0
+0.1
Note The ID Tag’s diameter is only 4 mm, but drill a hole about 4.5-mm in diameter to
allow the adhesive to flow around the Tag and fill the gap between the Tag and
the hole walls.
Recommended Adhesive
We recommend an epoxy adhesive when mounting the ID Tag to a resin or plas-
tic surface. Verify that the epoxy’s approved temperature range exceeds the
maximum ambient temperatures where the ID Tag will be mounted.
Note Epoxy adhesive may not provide enough holding strength when the ID Tag is
being mounted to polyethylene, polypropylene, Teflon compounds, or silicone
compounds. Contact the adhesive maker for details on compatible surfaces.
V700-D
j
3P41(-Y)
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : [email protected]