Omron SYSMAC 3G8F7-CLK12-E, Руководство по эксплуатации

Страница: 41 / 166

2-1 Section Connecting Wired Systems
25
d) The lines can be connected to either the right or left half of the con-
nector at the node at either end of the network.
e) The shield wire connections are different if grounding each node
individually. Refer to 2-1-2 Communications Cable to connect the
shield wire to the connector.
8. Firmly secure each signal line with the signal line screw on the connector. An
ordinary flat-blade screwdriver with a tip that tapers at the end is not suitable
because it cannot be inserted far enough. Use a small flat-blade screwdriver
with a constant width. The appropriate tightening torque is 0.2 N-m.
Small flat-blade
screwdriver with a
constant width
S
S
Note The following screwdriver is available from OMRON.
Model: XW4Z-00C
Side Front
2-1-4 Connecting the Connector to the Board
Connect the connector on the communications cable to the connector on the
Board using the following procedure.
1, 2, 3... 1. Connect the connector on the communications cable to the connector on
the Board as shown below.
S
S
2. Secure the connector to the Board by tightening the screws on the connec-
tor. The appropriate tightening torque is 0.2 N-m.