18
2. Installation and connection
Cautions
(Prohibition (don'ts))
Do not obstruct the air inlets and outlets on the sides and rear of the UPS.
Do not place the UPS in an enclosed space or cover the UPS.
●
Doing so may lead to abnormal overheating or fire.
●
Temperature will increase inside the UPS and may cause a failure of the UPS and battery
deterioration.
●
Install the UPS 5cm or further away from the wall.
Do not use the UPS where the maximum temperature exceeds 40
°
C.
●
Battery deterioration will occur rapidly.
●
Doing so may result in a failure or malfunction of the UPS.
Do not exceed the specified ranges in the operating and storage
environments.
Do not install or store the UPS in the following types of places.
●
Places with high temperatures, low temperatures, or high humidity
●
Places exposed to direct sunlight
●
Places that are directly heated by a stove or other heat source
●
Places where the UPS may be exposed to vibration or physical shock
●
Places where there is dust, corrosive gas, salt, or flammable gas
●
Outdoors
●
Placing the UPS in these types of areas may result in malfunction, deterioration, and/or fire.
Do not install the UPS in other orientations.
Do not install the UPS on a structurally unsound base.
●
See "2-2 Installation" on page 20.
●
IP the UPS falls over, or if you drop it, injury may result.
Do not connect devices that exceed the output capacity of the UPS.
You can add extra devices with a plug strip. Note that the plug strip does not
permit the connection of devices that exceed the current capacity of the
plug strip.
●
The UPS may detect overload and stop the output.
●
The plug strip cord may heat up and could lead to a fire.
Do not connect to a device (such as a dryer) that uses half-wave rectification
in which AC power supply current flows in half-cycles only.
●
The UPS may fail.
Do not clip the cables, and do not use when the cables are bundled.
●
If the cables become damaged or overheated, there is a danger of electric shock or fire.
●
If the cables become damaged, immediately stop using the UPS, and make the necessary
repairs.In a case where the UPS is to be mounted on a rack, place it on the lowest part of the
rack.
Do not connect a device such as a voltage transformer or isolated
transformer to the output side.
●
Overcurrent may damage the UPS.
●
Even when connected to the input side, the UPS may fail or malfunction. Make sure to check
the operation before use.
