Omron CQM1-ARM21, Руководство по эксплуатации

Страница: 66 / 86

Top-down Method
Section 5-3
52
4. Put the CQM1-ARM21 in Protected Mode (Mode Bit OFF, then MOD
switch ON). The master will restart.
5. Prepare the AS-Interface network separately, using an addressing device
to set all slaves to the projected addresses.
6. Connect the AS-Interface power supply, cable and slaves to the CQM1-
ARM21; If all slaves have been configured correctly, their LED indicators
on the master should light, none should flash, and the CER LED should
go OFF.
5-3-2 Top-down, without addressing unit
If no separate addressing unit is available, the CQM1-ARM21 can perform the
task of assigning addresses to blank slaves. Since all slaves are factory-set to
address 0, they need to be added and re-programmed one by one.
1, 2, 3… 1. Connect the AS-Interface cable and power supply to the CQM1-ARM21.
2. Put the master in Setup Mode (MOD switch OFF, Mode bit IR m.01 ON).
3. Define each projected slave’s address and type (see 4-5-3-3,
Set_Permanent_Configuration). If necessary, set each slave’s parame-
ters (see 4-5-3-7, Set_Permanent_Parameter).
4. Connect one new slave, with address 0, to the AS-Interface cable.
5. Change the slave’s address from 0 to the projected value (see 4-5-3-5,
Change_Slave_Address).
6. If necessary, set the slave parameters (see 4-5-3-9, Write_Parameter).
7. Repeat steps 4-6 for all slaves.
8. If all slaves have been configured correctly, their LED indicators should
light, none should flash, and the CER LED should go OFF.
9. Put the CQM1-ARM21 in Protected Mode (Mode Bit OFF, then MOD
switch ON). The master will restart.