Omron CJ1W-FLN22, Руководство по эксплуатации, Страница: 190 / 277

Inspections Section 10-6
164
3. Select either of the following settings as the new IP address setting meth-
od.
• 192.168.250 + node number
• Setup area
The address specified as 192.168.250 + node number is the default net-
work address for the FL-net standard. The node number corresponds to
the value set using the node address setting rotary switch on the front of
the Unit. When
Setup area is selected, enter the IP address for the CS1W-
FLN12 confirmed in step 2.
4. Click the OK Button.
For the remaining settings, refer to the procedure under Replacing CS1W-
FLN12 with CS1W-FLN22 and write the settings fro the new CS1W-
FLN22. Each of the settings is enabled when the FL-net Unit is restarted
or the PLC power is cycled.
Note 1. The CS1W-FLN22 (and CJ1W-FLN22) do not support the IP address set-
ting methods
Unit rear rotary SW + node No. or Unit rear rotary SW . If ei-
ther of these methods is set the HER indicator on the front of the Unit will
be lit red. Use the above procedure to correct the IP address setting meth-
od to either
192.168.250 + node No. or Setup area .
2. Consider the following points when replacing a CS1W-FLN22 with a
CS1W-FLN12.
The following new functions provided by the CS1W-FLN22 cannot be used
with a CS1W-FLN12.
• Automatically detecting baud rate (100 Mbps)
• Setting data link data order
Even if these settings are transferred to the CS1W-FLN12, the FL-net Unit
will operate using a baud rate of 10 Mbps and the data link data order will
be in sequential order.
3. To replace a CS1W-FLN22 with another CS1W-FLN22, use the CX-FLnet
or FL-net Unit Support Software Ver. 1.60 or later. If an earlier version of
the FL-net Unit Support Software is used, the new functions of the CS1W-
FLN22 cannot be set (i.e., the FL-net Unit will operate using a baud rate of
10 Mbps and the data link data order will be in sequential order).