Omron CJ1W-FLN22, Руководство по эксплуатации, Страница: 174 / 277

Error Status Section 10-2
148
10-2 Error Status
The FL-net Unit will output error status to the following word in the PLC Data
Area Interface of the CPU Unit. This information can be used in troubleshoot-
ing errors.
10-2-1 Unit Status (Unit to CPU Unit)
1,500 + (25
×
unit number) + 6
The corresponding bit will turn ON when an error occurs
IP address setting error
Transceiver error
EEPROM error
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
FA Link (Common Memory) Area allocation error
Data Link (PLC) Area allocation error
Token monitoring timeout error
FA link operation
Readable receive
Bit Name Correction
8 FA Link (Common Memory)
Area allocation error This bit turns ON if there is a Common Memory allocation error in the local node
setting range of the FA Link (Data Link) settings. Use the CX-FLnet or FL-net Unit
Support Software to re-set the FA Link (Common Memory) allocation settings
9 Data Link (PLC) Area allo-
cation error This bit turns ON if there is a PLC Area allocation error in the local node setting
range or another node setting range of the FA Link (Data Link) settings. Use the
CX-FLnet or FL-net Unit Support Software to re-set the FA Link (Common Memory)
allocation settings.
10 Token monitoring timeout
error This bit turns ON if a token monitoring timeout occurs while the local node is hold-
ing the token. Processing may be delayed because of system traffic, so recheck the
system configuration or extend the token monitoring timeout setting with the CX-
FLnet or FL-net Unit Support Software.
12 IP address setting error The following cannot be used as IP address settings.
• Host IDs that are all 0 or all 1.
• Network IDs that are all 0 or all 1.
• Subnetwork IDs that are all 1.
• Addresses beginning with 127 (7F Hex).
Reset the IP address.
14 Transceiver error The communications cable may be disconnected. Make sure the cable is mounted
securely.
15 EEPROM error Restart the PLC. If the problem persists, replace the FL-net Unit.