7
System Configuration
Section 1-2
CJ-series PLCs
ID Sensor Units are connected as I/O Units in the system configuration, as
shown below.
Use the following procedure to connect an ID Sensor Unit.
1,2,3...
1.
Align the connectors and press in firmly on the Units to connect them com-
pletely.
2.
Move the yellow sliders on the top and bottom of the Unit to the lock posi-
tion to secure the Units. The sliders should click into place.
3.
Attach an End Cover to the Unit on the right end of the Rack.
Note
The CJ-series PC may not operate properly if the sliders are not locked firmly
into place.
SYSMAC
CJ1G-CPU44
PROGRAMMABLE
CONTROLLER
RUN
ERR/ALM
INH
PRPHL
COMM
OPEN
PERIHERAL
PORT
MCPWR
BUSY
V600C11
RUN ERC
ERP ERH
T/R NORM/ERR
TEST
ON
HEAD
V600C12
RUN ERC
ERP ERH
HEAD1
HEAD2
T/R NORM/ERR
T/R NORM/ERR
TEST
ON
HEAD1
HEAD2
Power Supply Unit
End Cover
(included with CPU Unit)
CPU Unit
I/O Units
(10 Units max.)
Hooks
Connector
Hook holes
Locked
Slider
Released
Move the sliders to the back
until they click into place.
Содержание CJ - 12-2004
