Omnitracs MCP50, Инструкция по установке и устранению неисправностей

Страница: 24 / 124

Installing Antenna Antenna Installation
5-2 80-JB566-1 Rev. G
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
GPS Screen
Installing Antenna
1. Separate the two sides of the supplied Dual Lock tape.
2.
Clean the surface of the antenna where the Dual Lock tape will be applied with the
provided alcohol wipe. Once the surface is dry, adhere one side of the Dual Lock tape.
Apply firm pressure to the tape. The preferred method is to attach the dual lock tape to
the bottom of the antenna wherever possible.
3.
Clean the mounting surface in the truck thoroughly, let dry, and then adhere the other
side of the Dual Lock tape. Apply firm pressure to set the tape.
4.
Attach the antenna to the mounting location. Ensure the locking hooks of the tape are
fully mated.
5.
Route the antenna cable leads to the VTM and carefully mate the two connectors to the
VTM “Comm” and “GPS” slots. Be sure the wire leads are not kinked when routing and
the connectors are not bent or bumped in later steps when connecting other cables to
the VTM.
The connectors are color-coded and keyed to prevent mismating. There is a push down
tab at the top of each connector to remove the connector.
6. Secure excess cable so that it does not rub on any sharp edges or is routed over heat
sources in the dash. Be sure the cable will not be pinched when dash panels are
replaced.
1.00
7/12