Omnia Omnia.9, Инструкция по установке и эксплуатации

Страница: 72 / 127

64
Using an RDS Encoder That Does Not Provide a Pilot Signal
Some RDS encoders take the pilot signal of the processor, use it as a sync reference for RDS, and
then output only the RDS data without passing the pilot.
In this situation, you can use a T-­‐connector on Omnia.9’s MPX 2 Output, connect one leg of the tee
to the Pilot Input (Sync) on the RDS encoder, and connect the other to one Omnia.9’s MPX 1 Input.
The output of the RDS encoder should be connected to Omnia.9’s MPX 2 Input.
In this scenario, set the MPX 2 Output control to the 19kHz Generator mode and the External Input
to the 1+2 mode in so that both MPX inputs are enabled for RDS.