Omnia Omnia-6EX, Инструкция по установке и эксплуатации

Страница: 102 / 125

Omnia-6ex Use and Operation Manual – V: 1.20
102
syspara 2 1
<enter>
This tells the processor to switch the input to “Stereo.” “syspara 2” says to edit the Mono Mode setting. The “1”
says to select stereo mode.
When you are finished, the contents of the Trigger HIGH Command Script box should look like:
syspara 54 32
syspara 2 1
These four commands are now a completed script for Trigger 1. To test the scripts, click the Test button above each
edit box. If no errors or other displays are shown, then your script is ready to be used or saved. An error indication
typically indicates you have a “typo” in one of your command lines. Verify the command is correct and that the
index numbers for the parameters or parameter values are correct.
In order to use the scripts, they must be loaded into the Omnia-6EX. This is done by clicking Apply. Previously
entered scripts in the Omnia-6EX’s memory are then replaced by your new scripts. To save the edited Script Editor
scripts to the PC Card, click Save to Card. To recall previously edited scripts, click Load From Card. These can then
be sent to the Omnia-6EX by clicking Apply.
To actually use the scripts you have just written requires that a sustained relay or a switch be connected between
trigger input 1 (pin 1) and ground (pin 5) on the Interface connector on the processor's back panel. Setting the relay
or switch on (shorting pins 1 and 5 together), then causes the Omnia-6 to follow the script for go low (the unit
switches to Mono Left/Pilot off operation). Opening the switch or relay will then cause the processor to follow the
go high script (the unit switches to stereo/pilot on operation).
Multiple operations, including ones that are vastly more complicated than what we have presented here, such as
simultaneously changing to different presets when changing from stereo to mono, can be completed at the flip of any
one of the eight switches or relays connected to the Omnia-6EX. And the eight relays or switches do not have to be
switched locally: Commands can even be initiated by a network satellite when a receiver with contact closures is
being used.
Different Ways to Use the Script Commands
There are two methods of using the script we just created. One is to use the scripts as Trigger Scripts, responding to
contact closures and opens as previously discussed. The other involves integrating the scripts into the Omnia-6EX’s
daypart table. Because the processor is flexible, it allows one to use the same script for both options.