Omega CL1000 Series, Руководство пользователя

Страница: 7 / 24

Section 2 - Installation
2.1 Unpacking
Remove the packing list and verify that you have received all your equipment.
If you have any questions about the shipment, please call our Customer
Service Department at
1-800-622-2378 or 203-359-1660. We can also be reached on the Internet at
www.omega.com
e-mail: cservice@omega.com
When you receive the shipment, inspect the container and equipment for any
signs of damage. Note any evidence of rough handling in transit. Immediately
report any damage to the shipping agent.
The carrier will not honor any damage claims unless all shipping material is saved for
inspection. After examining and removing contents, save packing material and carton in the
event reshipment is necessary.
The following items are supplied in the box:
• This Manual, # M-3529 (1 ea.)
• Power Cord (1 ea.)
• Calibration Certificate (2 data points)
• Soft Carrying Case (1 ea.)
2.2 Mounting
Mount the unit in an ambient environment between the specified 32 to 122°F
(0 to 50°C) on a bench, table top or shelf in a horizontal position and operate at
least ten inches from any air obstructions to the fan, front panel or rear panel.
Do not block the bottom or top vented covers of the unit.
2.3 Environmental Operating Conditions
This unit is intended for indoor use only. Avoid exposure to moisture. The
CL1000 is a Class II instrument. It is intended to be operated in laboratory
environment only.
2.3.1 Ambient Temperature Effects
The probe well of the CL1000 can be controlled to any temperature within the
specified temperature range of a11 to 260°C (a20 to 500°F)
when being operated in ambient temperatures up to 24°C (75°F).
When operating the unit at higher ambient temperatures, do not exceed the “Maximum
Allowable Probe Well Temperature” shown in Figure 2. Failure to adhere to these guidelines
may cause a safety switch inside the unit to open the heater circuit. If this occurs refer to
section 3.2.6.
CL1000 Series Installation
2
2-1
NOTE:
NOTE: