Olympus USG-400, Руководство по обслуживанию

Страница: 19 / 90

USG-400
ISSUE1 3-5 Installation and Connection
The THUNDERBEAT performs cutting and coagulation using high frequency (RF
bipolar) and ultrasonic energy. When it is used, both the compatible
electrosurgical and ultrasonic generators are required.
To transmit the high-frequency (RF bipolar) energy from the compatible
electrosurgical generator to the ultrasonic generator, a docking connector and
docking plug are provided on each of these generators.
To connect the two generators, align the docking connector at the bottom of the
compatible electrosurgical generator into the docking plug at the top of the
ultrasonic generator.
After the alignment is made, the compatible electrosurgical generator is placed
on top of ultrasonic generator (see Figure 3.1).
This section describes how to connect and disconnect the docking connector
and docking plug.
Figure 3.1

Connection
1.
Preparing the docking fixture
Prepare the docking fixture (MAJ-1876).
The docking fixture includes the tools for use in connection, including
2 fixture plates, 14 screws (12 pcs for the fixture plates and 2 pcs for the
docking plug cover) and a hex wrench.
All of the screws used in the connection between the compatible
electrosurgical generator and ultrasonic generator should be
tightened/loosened using the hex wrench.
2.
Checking the docking plug cover
Confirm the position of the docking plug cover, which is a rectangular plate
on the top panel (near front) of the ultrasonic generator (see Figure 3.2).
Behind the docking plug cover is the docking plug for connection of the
compatible electrosurgical generator.