Olympus IPLEX LX Series, Инструкция по эксплуатации

Страница: 150 / 168

142
Chapter 9 Troubleshooting
The system cannot
be turned off. The main unit is damaged. Remove the AC adapter or the
battery from the main unit to turn off
the power.
The image is not
sharp. The object lens on the scope distal
end or the optical adapter is dirty. Wipe them with a clean piece of
gauze or cotton swab.
The optical adapter is attached
improperly. Attach the optical adapter properly.
The external monitor is adjusted
incorrectly. Correctly adjust the external
monitor.
The image
brightness is not
optimum. The automatic brightness control is
set erroneously. Perform the [BRT] lever operation to
configure the proper setting.
The object lens on the insertion tube
distal end or the optical adapter is
dirty or the illumination on the optical
adapter distal end is dirty. Wipe them with a clean piece of
gauze or cotton swab.
The external monitor is adjusted
incorrectly. Correctly adjust the external
monitor.
The optical adapter is old. Replace the optical adapter.
Color reproduction
is poor. The white balance is set improperly. Re-adjust the white balance.
The image is
noisy. The automatic brightness control is
set erroneously. Perform the [BRT] lever operation to
configure the proper setting.
Angulation cannot
be returned to its
original attitude. The angulation lock is set. Lift the [ANGLE LOCK] lever to
release the angulation lock.
Angulation cannot
be locked. A stopper is installed. Remove the stopper and then
operate the [ANGLE LOCK] lever.
Operation load for
articulation is
getting heavier. Angle lock function may effect. Pulling down the [ANGLE LOCK]
lever.
Control unit is
emitting loud noise
or vibrating
violently. The insertion tube is overloaded. Remove your finger from the
[ANGLE] joystick and then extend
the insertion tube as much as
possible to reduce the loop amount.
The beep can not
be heard. “BEEP ON/OFF” in the “SETUP”
menu is set to “OFF”. Set “BEEP ON/OFF” in the “SETUP”
menu to “ON”.
Problem Possible cause Remedy