Olympus BX-RFA, Инструкция по эксплуатации

Страница: 15 / 52

11
–
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦ : Recommended combination.
¦ * : Usable, but image be dark depending on NA.
–– : Not usable, or applicable objective is not available.
¦ ** : A phase contrast (Ph) objective is necessary for phase contrast observation. The Ph objective is not
available for the UPlanFI100XO I 3.
4
Turning the Power Supply Unit On
Set the main switch to “ I ” (ON). The arc will stabilize in 5 to 10 minutes after ignition.
}The discharge type mercury burner may not be ignited from the beginning on rare occasions due to its characteristics.
In this case, set the main switch to “ ” (OFF), wait for 5 to 10 seconds, then set it again to “ I ” (ON).
# To extend the mercury burner life, do not turn the mercury burner off for 15 minutes after ignition.
# The mercury burner cannot be reignited until the mercury vapor has cooled down and liquefied. Before re-igniting
a mercury burner, wait for about 10 minutes after the last time it was turned off.
}For the shake of safety, the power supply to the lamp housing is shut down if the lamp housing is opened while the burner
is on. If this happens, set the main switch to “ ” (OFF), wait for more than 10 minutes, then set it again to “ I ” (ON). Do not
open the lamp housing until it has cooled down enough.
# To reset the hour counter, hold its reset button till “000.0” is displayed.
Objective
Reflected light fluorescence
U, V, BV B, IB, G, IY
Phase contrast
difference
Transmitted
light DIC
UPlanApo 4X
10X
10X O
10X W
20X
20X O3
40X
40X
O
Ι
3
60X
60X
W3
100X O
Ι
3
PlanApo 40X
60X
O3
100X O3
UPlanFI 4X
10X
20X
40X
60X
O
Ι
3
100X O, O
Ι
3
UApo 20X 3/340
20X W3/340
40X 3/340
40X O
Ι
3/340
40X W3/340
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦ ¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦ –
¦
**
–
–
¦
**
–
–
¦
**
–
–
¦
**
–
¦
¦
–
¦
¦
¦
¦
–
¦
¦
–
¦
–
¦
¦
¦ –
¦
**
–
–
¦
–
¦ *
¦
*
¦ *
¦
*
¦
¦
¦ *
¦
*
¦ *
¦
*
¦
¦
–
¦
**
¦ **
¦
**
¦ **
¦
**
¦
¦
¦
¦
¦ ¦
¦
¦
¦
¦ –
–
–
–
–
UIS Series