Calstar
操作及保養
說
明書
OPERATION AND MAINTENANCE
HANDBOOK
A10Ex
27
出
.
回收完畢後
﹐機器會自動關機﹐運轉指示燈熄掉﹐而数字温控器會亮保持亮著
.
(
The unit starts working automatically according to the temperature set on the distillation thermostat.
The distilled product will start coming out. At the end of the cycle, the unit automatically shuts off. The
working light switches off, and the Heating Temp Control remains on.)
無論何種理由
,
請勿觸摸回收桶
﹐以免高溫燙傷
!
Never touch, for any reason, the upper side of the tank during the distillation cycle.
)
無論何種理由
,
請勿在執行回收過程中傾倒回收桶
!
Never overturn, for any reason, the tank before the end of the distillation cycle.
)
無論何種理由
,
請勿在執行回收過程中鬆開桶蓋手柄
!
Never unscrew, for any reason, the lid knob before the end of the distillation cycle.
)
無論何種理由
,
請勿在執行回收過程中打開電控箱
!
Never open, for any reason, the lid before the end of the distillation cycle.
)
16.0
殘渣清除及清潔機器
,
如下圖所示
(RESIDUALS DISCHARGE AND
UNIT CLEANING ,Pictured below ):
每次回收結束後
﹐必須將回收桶內殘渣清除乾淨﹗﹗﹗
(The tank must be cleaned from residuals at the end of every
distillation cycle!!)
特別提示
(Reminder):
※
回收桶
內積累殘渣是非常危險的
!!
﹗這不僅會造成機器回收效率嚴重降低而且局部過
熱引起回收桶變形
﹑開焊
,
還會造成殘渣冒煙起火
!!
﹗
(
If the accumulated residues within the tank are not cleaned, it will damage the unit. Not only
can it significantly decrease the working efficiency, but the high temperature can deform the
tank, and can possibly start a fire.
)
當結束回收蒸餾後
﹐在打開桶蓋執行清渣工作之前﹐請確認熱媒
油
溫度錶之溫度
﹐如果溫度還很高﹐則清渣時必須小心處理﹐以免燙
傷
﹗﹗﹗
When cycle is over, check the Heat Transfer Oil temperature on the
thermometer, before opening the lid and carrying out the residuals discharge.
Open the lid to discharge the residuals with greatest care in relation to residual
temperature.
16.1
回收桶清潔程式
(
Tank cleaning procedure
)
●
扳回
啟動開關至
“
0
”
位置
﹒關掉提供回收機電源之閘刀開關﹒
(
Turn the lever of the switch
to position 0 (zero).
)
●
檢
查熱媒油溫度錶之溫度
(
其
溫度與殘渣之溫度很接近
),
確定熱媒油
溫度錶已降至接近室
