olympia electronics BS-429/W, Быстрое руководство по установке

Страница: 20 / 28

Page 20 921468007_90_005
By choosing "INFORMATION" in the menu the user sees:
With "

2" and "

8" keys we be can transferred to
the required option and select it by pressing the " *

" key. We can get information about the keyboard
firmware version, the panel firmware version,
information regarding the technician supporting the
system and the signal level (If a GSM card is
connected).
The selection "TECHNICIAN INFO" by default has
information of Olympia electronics.
If "SIGNAL LEVEL" is selected and a GSM module is
not connected, then the following message is
shown.
7.6 Wireless Zones Events
•
Wireless zones can produce some extra events than wired zones. The common
event with wired devices is the tamper event, which when open, it will trigger an
alarm, unless the user is inside "TECHNICIAN MENU". Also, if there is motion
detection on a motion sensor, it will trigger an alarm event only if the system is
armed. While the system is disarmed, an information on the "WIRELESS
SENSORS" menu screen is depicted.
•
If a wireless device does not communicate with the panel for a long time (2
hours), in a disarmed system, it is recorded as an error in the events log. If the
same error occurs in an armed system, an alarm will be triggered.
•
If the battery level on a wireless device is low for 12 hours, a low battery fault is
generated. After battery replacement, the fault will be reset in a maximum of 6
minutes time.
•
If a user gets out of technician menu and there is tamper alarm active in a
wireless device, the siren will not sound for the specific zone. However the
"Tamper Alarm" event will exist on the keypad screen.
8. BS-468/A REMOTE CONTROL
8.1 General
The wireless alarm kit you have purchased, has 2 remote controls pre-installed for
remote operation of basic functions. No additional settings are needed to
_____INFOMATION_____
KEYBOARD SOFT VERS.
PANEL SOFT VERSION
TECHNICIAN INFO
SIGNAL LEVEL
NO GSM CONNECTED
PRESS
‘#’ TO RETURN