olympia electronics BS-429/W, Быстрое руководство по установке

Страница: 12 / 28

Page 12 921468007_90_005
INSTALLATION PROCEDURE : For the best possible ease and speed, have the devices
in front of you. Put the BS-468/A panel in installation mode and place the batteries
one at a time on the devices, followed by tamper press and release after each
battery installation. When you get the message that the device has entered a zone,
proceed to the next device until you complete with all the devices. When you finish,
you can install the devices in place (e.g. the magnetic traps are placed on the doors
and windows and so on).
5.2 Device’s control operation
1. From the corresponding menu, check each device's signal strength, which should
be at least 2/4 to be considered satisfactory.
2. Check the tampers. You should leave the menu only when it says "ALL ZONES
ARE OK". If a zone flashes, you should check the specific device's tamper. Be
careful if a zone is in "Disabled - Off" mode. The tamper alert never flashes even
if it exists.
3. As far as magnetic sensors are concerned, open the door or window on each one
of them, watching the keypad's screen changing. As of PIR sensors (radars), pass
in front of the radar to see if the red LED on the radar lights up and the keypad
screen changes. Let it be noted that radars turn on the LED on each activation,
only in the technician menu. Be careful if a zone is in "Disabled - Off" mode. The
sensor activation alert never flashes even if it exists.
6. BASIC SYSTEM CONFIGURATION
6.1 Zone settings
The entry - exit points of the guarded space must be set as "Zone with delay", for
the user to have enough seconds to disarm the system. Whether they are magnetic
contacts on doors, or motion detectors that see these doors or magnetic connectors
connected to the external input of one of the devices, they must have a delay. The
remaining windows and doors, either infrared or magnetic sensors, can be set as
zones without delay. If these sensors are triggered in an armed system, they will
immediately give alarm signal. If a zone is set as "Disabled - off", it means that the
specific device cannot give an alarm. Keep a note that "zone bell" has no power for
the wireless zones, which do not cause a bell event, regardless of the bell menu
selection.
6.2 Section configuration
If a user wants to have an armed system while being inside the guarded area, then
the magnetic contacts must be in a different section from the motion sensors, so
that only the magnetic devices' section is armed. When you leave the guarded area,
you can arm all areas normally.