olympia electronics BS-429/W, Быстрое руководство по установке

Страница: 7 / 28

Page 7 921468007_90_005
2. DETECTION OF NETWORK’S DEVICES
2.1 Wireless keypad detection
CAUTION: The choice of placing the panel is very important for the signal’s
strength, because all the other devices are communicating with the panel. Avoid
(especially in big places) to place the panel to terminal places, where the distances
with some devices are big. Also, avoid placing close to metal surfaces or behind thick
walls. They are suggested places near to the center of the protected area.
NOTE: If you have purchased the wireless kit, then the BS-477 wireless
Keypad inside the kit is already synchronized with BS-468/A panel. You only need to
install all the other devices from the BS-477 menu. If you have purchased the panel
with the Keypad separately, then you must first synchronize the keyboard with the
panel and then install the rest of the devices from the BS-477 keypad. Below the
whole procedure is described. If you have purchased the whole kit, then you must
directly go to step 2.
The procedure must be done before the installation of any other device. The
procedure is simple and it is performed using 1 push-button of the BS-479 expansion
card. The process is separated into 2 parts. The first part includes the devices
detection and the second installs a wireless keypad. When the BS-477 wireless
keypad is installed, the installation of the other devices can be completed by the
keypad menu. In order to continue, focus on the BT1 button and the LD4 LED (green)
of the BS-479 card. The total time of the STEP 1 procedure is about 2 minutes.
First, the BS-468/A panel should recognize the BS-479 wireless zone extension. This
search includes all connected devices, extensions and wired keyboards. The BS-477
batteries that will occupy zone 25 must not be installed and the tamper must not be
depressed. The procedure is as follows:
1. Connect the panel to the mains and wait for 30 seconds to initialize. LD4 (green)
is off at this stage.
2. Press button BT1 for about 3 seconds until LD4 lights up. Then release the
button.
3. Wait about 60 seconds until LD4 starts blinking, indicating that device scanning is
completed.
4. Insert the batteries into the BS-477 keypad. The panel detect it and will import it
to its network. At the same time the LD4 will go out.
5. Wait for about 15 seconds in order BS-477 screen and LEDs are refreshed. BS-
477 Keypad installation has been completed. The other devices can now be
identified by the keypad's technician menu.
6. End of procedure.
NOTES:
i.
During the above procedure, do not attempt to add another device to the
network (e.g. siren, magnetic contact, etc.) other than the keypad. No other