49.
Locate all four
Y35 - Roller Assemblies
. Before attaching to top of
doors, assemble the units as shown above. Attach two Roller Assemblies
to each door with
4 - 1 1/4” Screws
per Assembly, center on the door
framing 4” from each end as shown above.
Next, take Left Side Door and slide Rollers into the Aluminum Door Track.
Repeat with Right Side Door and slide until doors meet in the middle.
Left Side Door
Parts
4F - Sliding Doors
(36” x 73”)
x 2
Right Side
Door
Twist Roller Cart onto bolt.
After doors are hung, you may need
to adjust this until doors hang
straight up and down at equal height.
Wider door trim
towards center.
Hardware
S2 - 1 1/4” Screws
x 16 total
Y35 - Roller Assembly
x 4 total
Note:
If there is a gap between your
doors at the top or bottom, remove the
door and twist the Roller Assemblies to
adjust the height until they hang parallel.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 30
