Oliver Packaging & Equipment Company
3236 Wilson Drive NW, Walker, MI 49534
(800) 253-3893
747-N BREAD SLICER
0747S20007
6-4
Changing Slice Thickness
WARNING
ALWAYS DISCONNECT THE SLICER FROM THE POWER SUPPLY BEFORE
ATTEMPTING ANY TYPE OF MAINTENANCE TASK.
WARNING
BLADES ARE EXTREMELY SHARP. ALWAYS HANDLE
BLADE FRAMES WITH CARE.
•
Follow the steps in the previous section to remove the blade frames.
•
Remove hold down using the two hand knobs.
•
Move the pusher to the downward end of the stroke position in front of the
machine and remove it using the two wing nuts or knobs (on the back side of the
pusher). Note: This downward position allows easy access and verification that
the correct slice spaced parts are being installed as the slots in the pusher and
hold down will align with the blades if the correct components are used during
reassembly.
•
Install pusher for new slice thickness
•
Install hold down for new slice thickness
•
Replace the blade frames following the steps outlined above.
•
Install upper outfeed table for new slice thickness.
Note: Insert the tabs in the slot under the infeed table (through the blades).
•
The alternate sized blade frames, pusher, hold down and outfeed table may be
stored in the base compartments when not in use.
IT IS RECOMMENDED TO STORE BLADE FRAMES IN PACKAGING TO PROTECT
EDGES AND PREVENT INJURY.
HOLD DOWN PLATE
HAND KNOBS
