Oliver Packaging & Equipment Company
3236 Wilson Drive NW, Walker, MI 49534
(800) 253-3893
747-N BREAD SLICER
0747S20007
6-13
WARNING
ALWAYS DISCONNECT THE SLICER FROM THE POWER SUPPLY BEFORE
ATTEMPTING ANY TYPE OF MAINTENANCE TASK.
Adjusting the Blade Frames When Slices Vary in Thickness
The blade frames can be adjusted laterally from side to side to make the spaces
between the blades equal. On the front of the slicer remove the four knobs and
remove outfeed covers and bagging scoop. Loosen the set screws on the front
blade frame rod (shown) and push (a lever may be needed) to move the blade frame
slightly left or right as necessary to equalize the gap size between the blades. Re-
tighten the set screws when the alignment is satisfactory. The rear blade frame
position may be adjusted if both blade frames are too far left or right. The set screws
for the rear rod are on the opposite side of rocker (back).
SET SCREWS (5/32 HEX KEY
WRENCH REQUIRED)
