732-N Front Load Slicer
0732S20007
6-6
Changing The Blades (Continued)
The new knife can be installed in the upper blade frame by reversing the removal
procedure. A paper clip can be used to hold the knife in position on the lower pin to
ease installation. See the illustration below. Remember to make sure that the sharp
edge of the blade is pointing in the same direction as the edge on the blade which was
just removed. Also remember to remove and replace one blade at a time.
The blades can be removed from the lower blade frame while it is still in the machine.
This is done by using a second special blade changing tool. Insert the tool into the blade
frame, push the handle toward the feet of the blade frame as shown below. This will
reduce the tension on the blade so that it can be carefully removed.
Using the same technique as used on the upper blade frame, replace the knives in the
lower blade frame.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor