Oliver 4265, Руководство пользователя, Страница: 40 / 70

40 | Page Oliver Machinery 4265 Jointer
3. Make sure the straight edge is hanging
above the cutterhead:
4. In each position, carefully rotate the
cutterhead. When outfeed table is in parallel
with cutterhead, cutters should be barely
scraping the straight edge when cutterhead
rotates.
5. If outfeed table and cutterhead are out of
alignment, move to section “ Adjust Table
Parallelism/Coplanarity ”.
If outfeed table is in parallel with cutterhead,
proceed to next section “ Inspect Infeed Table ”
Inspect Infeed Table
1. Disconnect jointer from power source!!
2. NOTICE: Make sure the outfeed table is
properly adjusted before continue.
3. Place a straight edge that splits evenly on
both infeed and outfeed table.
4. Raise the infeed table so that it is at the
same height as the outfeed table. When
proper height is set, the straight edge will sit
flat and flush with both infeed and outfeed
table. Rotate carbide cutter away if it
contacts the straight edge.
5. Move the straight edge across the tables in
positions as shown in the picture below.
Rotate carbide cutter away if it gets in the
way.
6. In each position, the straight edge should sit
flat and fit flush with both infeed and
outfeed tables.
7. If infeed / outfeed table are out of alignment,
move to section “Adjust Table
Parallelism/Coplanarity”.
8. Otherwise, congratulations! The jointer
tables are well calibrated for your next
project!