Oliver 4265, Руководство пользователя, Страница: 13 / 70

4265 Jointer OLIVERMACHINERY.NET 13 | Page
minimize dust. Use anti-skid floor strips on the floor area where the operator normally stands and
mark off machine work area. Provide adequate work space around the machine.
9. ACCESS CONTROL should be enforced so only trained personnel can access the work area and operate
the machine. Use childproof power switch when applicable.
10. STAY ALERT at all times. Do not operate this machine while under the influence of drugs/alcohol, or
when not feeling well.
11. REPLACEMENT PARTS: Use only genuine Oliver Machinery replacement parts and accessories
recommended for this machine. Generic parts made by other manufacturers may create a safety
hazard, and WILL void the factory warranty and other guarantees.
12. PROPER USE: Do not use this machine for other than its intended use. If used for other purposes,
Oliver Machinery disclaims any real or implied warranty and holds itself harmless for any injury or
damage which may result from that use.
Safety Guidelines Specific to Jointer
Before Work Begin:
1. USE ONLY NATURAL, SOLID WOOD. Do not joint any material such as plywood, MDF, OSB, laminate
or anything that can disintegrate during operation. Do not joint treated lumber or anything that
contains harmful chemicals, as this will spread wood dusts that contain such harmful chemicals. Do
not attempt to joint workpiece with loose knots or with any other foreign materials.
2. CHECK CUTTER INSERTS: Make sure cutter inserts are sharp, clean, and free from damages. Forcing
dull/damaged cutter inserts to work invites accidents, and lowers the quality of the finish. Use
recommended amount of torque to securely fasten all inserts onto the cutterhead.
3. SERVICING CUTTER INSERTS: Wear heavy duty leather gloves to protect your hands when installing
new cutter inserts or rotating the existing ones. Ensure the cutterhead is thoroughly clean before
installing the insert. Debris between the cutter insert and the platform can create uneven pressure,
causing the insert to break, and body injuries may occur.
4. CHECK CUTTERHEAD GUARD: Make sure the cutterhead guard is installed and is properly tensioned.
The cutterhead guard should spring back and push against the fence, after it is rotated away and
released.
5. CHECK OUTFEED TABLE HEIGHT AND ALIGNMENT to avoid a workpiece getting stuck while feeding.
6. CHECK DEPTH OF CUT SETTING. Maximum depth of cut for each pass is 1/8”.
7. SUPPORT LONG WORKPIECE with auxiliary stock feeding rollers/tables. This will help avoiding
injuries and improve quality of finish.