Oktober 7, Руководство по эксплуатации

Страница: 19 / 22

Other Maintenance
Seaming Rollers:
The bearings in the seaming rollers are oil-impregnated bronze bearings and are
nearly maintenance free. If the rollers become sticky, they probably need to be
thoroughly rinsed with water to break up the sticky residue.
In extreme cases, you can remove the entire roller assembly out of the seamer
and soak it in warm water (see diagram above). 15 minutes should be enough to
loosen up sticky residues. Work the roller by hand until it becomes free and easy
to rotate. Dry everything off and add a few drops of food-safe oil (like super-lube)
above and below the roller. Spin the roller to work the new oil into the bearing
and its axle.
Re-assemble as described above.
Troubleshooting
Can does not spin when seamer is turned on
Sometimes during shipping, the motor gets displaced enough for the drive belt to
slip off the pulleys.
Unplug the seamer and remove the top cover and check to
make sure the belt hasn’t fallen off the pulleys. If it has, you should be able to slip
the belt back on by first placing the belt over the small pulley, then pull it over the
large pulley while rotating the pulley by hand.
If the belt continues to fall off after
it has been placed back on the
pulleys, you may need to align the
driver pulley. This can happen when
the box is dropped during shipping
and the motor becomes misaligned,
but it is easy to fix. There is a small
set screw on the side of the pulley.
Loosen the set screw and raise or-