Oktober 7, Руководство по эксплуатации

Страница: 18 / 22

Roller Assemblies
-Loosen both vertical adjust locking screws.
-Remove the roller assembly retaining nuts and pull the roller assemblies down
and out of the housing.
-Rub a small amount of grease onto the roller assembly axle and place the new
roller assemblies up and into the housing. Make sure the brass washers are
oriented as shown below.
-Loosely re-tighten the roller assembly retaining nut until you feel a slight drag
when rotating the roller assembly arm. DO NOT OVERTIGHTEN.
Base Shaft Assembly and Can Guide Spacers
-Remove the base shaft assembly by removing the upper quick release pin and
pulling the shaft up and out of the housing. Replace with the new assembly.
-Remove the two button head screws retaining the can guide spacers and replace
them with the new spacers.