Oktober 7, Руководство по эксплуатации

Страница: 13 / 22

Calibration
If any of the measurements from the seam inspection aren’t within the
specifications, it may be time to adjust the seamer’s calibration.
Infeed Calibration
If the first or second operation seam thickness is incorrect, you can adjust them
by adjusting the infeed adjuster screws (see diagram) The adjusting screws and
their locknuts can be accessed with the back cover still attached to the seamer
through access slots. The nut requires a 3/8in wrench and the screw requires a
5/32in allen key.
To decrease the operation seam thickness, loosen the adjuster screw nut, and
turn the screw counterclockwise.
If the seam is too small turn the screw clockwise.
Each rotation adjusts the thickness approximately .001in.
After adjusting the screw, run the operation again and measure the new seam
thickness. Continue to adjust, test, and re-measure until the seam thickness is
within the specification.