-------------------------------------------------------------------------------------------------------------
Changing Tooling
To change between different end sizes, you will need to swap out the upper
chuck, 1
st
and 2
nd
operation roller assemblies, the base shaft assembly, and the
can guide spacers. You will also need to re-calibrate the base force and roller
positions (see instructions above).
Upper Chuck
-First remove the top cover.
-Remove the drive belt by pushing an edge of it off the large pulley and spinning
that pulley by hand. The belt should slide off easily.
-loosen the set screw located on the side of the large pulley
-remove the large pulley’s locknut. Make sure to hold onto the upper chuck while
removing the nut to make sure the chuck doesn’t fall out of the bearings.
-Pull the upper chuck down and out of the bearings. Pay attention to the
orientation of the bearings, as they must face a certain direction.
Содержание 7
Страница 4: ...MODEL 7 SEAMER DIAGRAM...