Oktober 7, Руководство по эксплуатации

Страница: 17 / 22

This side faces out This side faces the inside of the housing
-Place the new upper chuck into the bearings and housing. The chuck fits very
precisely into the bearings but should slide in without a lot of force. Don’t force
the chuck into the bearings or it can get stuck.
- See diagram below. Reassemble the washers and spring washer and pulley as
shown. Make sure the concave side of the spring washer faces down.
-Thread on the Locknut and tighten it by hand.
-Lightly tighten the pulley set screw onto the flat surface on the side of the upper
chuck.
-Tighten the pulley locknut just enough to flatten the spring washer.
-Replace the belt by first placing it over the small pulley, then pull it over the large
pulley while rotating the pulley by hand.