OKIDATA Okipage6e, Руководство по обслуживанию

Страница: 206 / 250

Page: 121
Service Guide OKIPAGE6e
Chapter E Multi-Purpose Feeder Maintenance
(1) Parts replacements must be carried out, by first turning the printer power switch off "O" and removing
the Multi-Purpose Feeder from the printer.
(2) Do not disassemble the Multi-Purpose Feeder if it is operating normally.
(3) Establish the extent of disassembly suitable for the purpose of the procedure, and do not disassemble
any more than necessary.
(4) Only specified service tools may be used.
(5) Disassembly must be carried out according to the prescribed procedures. Parts may be damaged if
such procedures are not followed.
(6) Small parts such as screws and collars can easily be lost, therefore these parts should be temporarily
fixed in the original location.
(7) When handling printed circuit boards, do not use any glove which may generate static electricity.
(8) Do not place the printed circuit boards directly on the equipment or floor.
Service Tools
Table 3-1 shows the tools required for the replacement of printed circuit boards and units in the field.
Table 3-1 Service Tools