Oki PACEMARK 4410, Руководство по обслуживанию

Страница: 88 / 189

40496501TH Draft Version
88
Item No.
1
Items
Protector Gap Adjustment
(1)Range Adjustment
(2)Protector Gap
Standard Value Illustration Adjustment Method
1 Remove the Rear Cover (B), and set
Dip Switch 1 on the board to “ON”
(maintenance mode).
2 Close the access cover, and turn on
the printer while pressing Switches 7
and 10 on the operation panel. (This
starts the auto gap adjusting mode.)
The platen moves forward/ backward
up to the adjusted position.
3
When the platen stops, turn off the
printer.
1
Insert the thickness gauge between
the platen and the protector frame to
verify the protector gap value B is bet-
ween 0.12 and 0.16 mm.
Notes:
Although the adjustment should use a
range from 0.12 to 0.16mm, the configura-
tion should use a range from 0.09 to 0.2mm
2 If adjustment is required, screw down
the ribbon guide post with the Philips
screwdriver and adjust the protector
frame to make the protector gap value
B between 0.12 and 0.16 mm, then fix
the protector frame.
Notes:
a) The protector frame should be
mounted parallel with the platen, when
measured at the right/left gap measur-
ing points.
DIP Switch
Lower Cover
Rear Cover (B)
ON
OFF
1 2 3 4
ON
OFF
1 2 3 4
DIP SW
Temporary
Maintenance
PARK TEAR
PATH
ONLINE
RESET
GROUP
POWER
ALARM
ITEM OPTION
MENU
STORE
TOF
SHIFT
O N - L I N E E P S
F R O N T F E E D
CONFIG
LF
MicroFeed
Down
FF/LOAD
MicroFeed
Up
1
2 3 4
5
6
7
8
9 0 A B C
1
2
3
Gap Measuring Points
Ribbon Guide Post Protector Frame
Platen
B
B