Oki B 6100, Руководство по установке

Страница: 30 / 52

3-6 Ethernet Network Interface Card (NIC) Installation
2. Replace the side cover of the printer.
3. Connect the appropriate network cable. For 10Base/100Base-T environments,
c
onnect a twisted pair
Ethernet cable to the RJ45 connector. For 10Base-2 environments, connect a thin coaxial Ethernet
cable to the BNC connector.
4. Plug the power cord in the AC outlet and turn the printer power switch to the ON [I] position.
NOTE: Before supplying power to the printer, be sure that only 1 physical Ethernet port is used.
NOTE: The BNC and BASE-T LEDs indicate good network connection. The OK LED gives information
about what the NIC is doing; for example, when code is being downloaded as the unit boots, the
LED will blink green quickly.
5. Allow 45 seconds for the unit to fully boot. The BNC or BASE-T green LED will be lit if there is a
valid connection to the network, and the NET yellow LED should blink slowly to show the unit is
functioning properly.
6. Print a Test page by pressing the TEST/RESET button.