Oki B 6100, Руководство по установке

Страница: 28 / 52

3-4 Ethernet Network Interface Card (NIC) Installation
Installing the Ethenet Network Interface on the Controller Assembly
NOTE: It is not necessary to remove the controller from your printer to complete the installation. For
clarity, the following illustrations depict a controller removed from the printer. When facing the
front of the controller as shown below, network port 1 is on the right and network port 2 is on the
left. However, when installed in the printer, network port 1 is on the bottom and network port 2 is on
top. In the following few steps, an Ethernet network interface is being installed in network port 2.
1. Turning thumbscrews counter-clockwise, remove the blank metal plate covering one of the available
network ports on the controller bracket.
2. While aligning the front bracket of the NIC assembly to the two respective thumbscrews on the con-
troller assembly bracket, firmly seat the 80-pin male connector on the underside of the NIC to the
80-pin female connector on the controller assembly.