Oki B 6100, Руководство по установке

Страница: 20 / 52

2-12 Ethernet Network Interface Card Configuration Guide
Using a Directed Ping Packet
1. Create an entry in the host’s ARP table that contains the NIC’s IP and hardware addresses.
2. Ping the NIC. If no other node is using the IP address, the NIC will use it.
3. To save the IP address, Telnet to the NIC and use the Define Server IP address command.
Using a BOOTP, DHCP, or RARP Reply
At boot time a host-based DHCP, BOOTP, or RARP server can respond to an NIC request for an available
IP address. For information about configuring the DHCP, BOOTP, or RARP server, see the host documen-
tation.
Notes About LPR
There are four important things to note about the LPR printing method:
1. Because of the way the LPR protocol is typically implemented on the host, the processing options and
banner page are sent after the job data itself. The NIC will print a banner page at the end of a job,
and cannot support most of the LPR options. If it is necessary to have the banner page at the
beginning of the printout, install and use the RTEL software. If banners are not needed, they can be
disabled.
2. The NIC cannot print multiple copies of the print job when using the “-#x” lpr option.
3. If two queues on the print host refer to two services on the same NIC, they must use separate spool-
ing directories.
4. No special purpose input or output filters can be used when printing via LPR. If this functionality is
necessary, use the named pipe interface program in the RTEL print queue configuration software.
LPR on Generic UNIX Hosts
The Berkeley remote printing system is supported on many machines, and is simple to configure.
This section describes how to configure LPR print queues on generic UNIX hosts such as SUN hosts. There
are slight variations in LPR configuration for AIX, HP, SCO, Solaris, ULTRIX, and Windows NT hosts.
After reading this section, refer to the following sections for further configuration information.
1. Start by adding the NIC name and IP address to the
/etc/hosts file:
2. Add the host print queue name into /etc/printcap , and then specify the remote node name (the host
name of the NIC) and the service name on the NIC. For example:
The punctuation shown is required, and no extra spaces should be added. This will create a host queue
named
prq_prt . The rm parameter is the name of the NIC in the host's address file, the rp parameter
is the name of the service as it exists on the NIC, and the sd parameter specifies the name of a direc-
tory used to hold temporary spooling files.
xxx.xxx.xxx.xxx PRQ_xxxxxx
prq_prt|Printer on LAB NIC:\
:rm=PRQ_xxxxxx:\
:rp=PRQ_xxxxxx_BIN:\
:sd=/usr/spool/lpd/PRQ_prt: