Oilon GKP-50 MH, Руководство по эксплуатации и обслуживанию

Страница: 34 / 100

4 Commissioning
4.1 First start-up
Vent fuel lines before first start-up.
After the first start-up check the cleanliness of the filter weekly and
replace if necessary. If the filter remains clean, inspection period can be
extended to one month.
Pump must not operate without oil. Vent the oil pump before initial start-
up and when changing the pump.
While adjusting burner, make sure that minimum and maximum values
for burner capacity are not exceeded. Values are marked on the type
label.
Fasten all safety covers, enclosures, and guards with all screws before
start-up. Use appropriate tools.
If burner start-up fails consecutively two times, do not restart burner
before carefully investigating the reason for the failure.
First start-up check list
Check the following before first start-up:
● instructions from boiler and burner manufacturers are followed
● piping is done properly, and joints on pipes and components have been tested for
leaks
● check that all screws are in their places and carefully tightened after installation
● boiler and its components are in proper working order and ready for use
● there is adequate air inlet to boiler room for burner to have sufficiently air for
combustion
● connections are correct and motor rotation direction is correct
● valves in supply line(s) are open and fuel is available at a suitable pressure
● manual control valves are in correct positions
● fuel filter is installed
● oil temperature and viscosity are correct
● chimney is properly connected, unobstructed and flue gas damper is open
32 (95) M5164 1640EN