Oilon GKP-50 MH, Руководство по эксплуатации и обслуживанию

Страница: 25 / 100

The assembly may vary depending on the scope of delivery.
To assemble the gas module:
Gas module parts are connected to each other with threaded connections. Use thread
seal to seal the connections (for example Loctite 577).
1. Screw the gas inlet pipe to the mounting flange (1.1).
2. Screw the elbow fitting to the gas inlet pipe. Adjust the fitting to point straight to the
right, in gas flow direction (when gas inlet to burner is on the right).
3. Screw the elbow part (4.2) of the adjustable elbow fitting and adjust it to point
upwards.
a029409 ver. 1
Pos. Item Pos. Item
5 2nd stage oil valve 13 Cable gland for gas high
pressure switch
6 1st stage oil valve 14 Gas valve cable gland
7 Main oil valve 15 Injector hoses
8 Gas high pressure switch 16 Hinge locking screw
9 Gas low pressure switch 17 Control unit
10 Manual shut-off valve a Flame detector gland
11 Gas valve assembly with pressure regulator b Gas damper servo gland
12 Cable gland for gas low pressure switch c Lead in plate
To mount the gas module to the burner:
1. Screw the coupling unit (4.1) of the adjustable elbow fitting to the burner gas frame.
The nut (4.3) must be with the coupling unit.
2. Lift the mounted gas module to the adjustable elbow fitting.
3. Check that the gasket (4.4) is in its place and undamaged.
4. Connect the gas line by screwing the nut (4.3) to the elbow part (4.2).
M5164 1640EN 23 (95)