６
-6．
Adjustment of the brush height
ᰴᘧ♫ࠉṊ࣭࣮ࣝࢺᕤᴗ
ᅗ
␒
㸿㸱
ᢎ
ㄆ
᳨
ᅗ
〇
ᅗ
タ
ィ
ኚ᭦␒ྕ
ᖺ᭶᪥
ኚࠉ᭦ࠉグࠉ
ᢎㄆ
ኚ᭦⪅
సࠉᡂࠉᖺࠉ᭶ࠉ᪥
సᴗෆᐜ
〇ရྡ
㸦㒊ရྡ㸧
B
㸯㸳㹱
Brush-base holder
screws
Height adj. screws
Brush
６
-
7
．
Adjustment of the rear hopper cover
Rear hopper cover fixing screws
Rear hopper cover
Put in screws to the feeder unit. Turn on and off the power switch to active
the unit so that screws fall into the rail.
･
By operating the power switch, adjust it so that the brush stops at the
horizontal position on the left side
･
Swing the brush by hand, and check if tip of the brush can touch top of the
screws on rail lightly.
･
If the brush is too low or too high, it will affect the screws’ supply speed.
･
When adjustment is needed, loosen the height adj. screws.
･
If plastic part of the brush touched the passing plate above the rail, please
adjust horizontal position of the brush with the base holder screws.
･
When adjustment is done, turn on the power and make sure that the brush
is functioning effectively.
-Please check that there’s roughly a 0.5mm-wide clearance between the back-plate and the rail.
-Please adjust the plate so that it is not too low to affect vibration of the rail, or too high so that screws became stuck within the opening.
- When adjustment is necessary, please loosen the screws , and adjust the height of the cover.
- １５-
６
-8．
Adjustment of the scrapers
･
Check that the clearances, between the scraper right/left and hopper wall right/left, are around 0.5mm.
･
When the scraper makes contact with the hopper wall, the rail vibration becomes weak and the screws are delivered slowly.
When the clearance between the scraper and the hopper wall is too large, the screws may be caught easily.
・
If any adjustment is required, loosen the scraper fixing screws and move the scraper up or down.
・
After such adjustments, if deformation on the plate has occurred so that proper
clearance and adjustment cannot be achieved, or
scratches on the plates had caused trouble in screw movement, please purchase replacement parts for best results.
Left Scraper : TPO91201 Right Scraper: TPO91202
Scraper
Scraper fixing screws
Hopper wall
Please make certain that the power is OFF when making adjustment to avoid personal injuries.
Please make certain that the power is OFF when making adjustment
to avoid personal injuries.
Please make certain that the power is OFF when making adjustment to avoid personal injuries.
