OHAUS TP200S, Инструкция по эксплуатации

Страница: 61 / 116

8
Draft Shield (TP200 and TP400D ) Draft Shield (TP200 and TP400D ) Draft Shield (TP200 and TP400D ) Draft Shield (TP200 and TP400D ) Draft Shield (TP200 and TP400D )
To install the draft shield:
1. Position the draft shield on top of the
balance as shown. Make sure the rib
at the front of the draft shield base
butts up against the raised lip of the
display panel.
2. The snap clamp should be
oriented so that the double
clip is toward the front of the
balance.
Insert the double clip of the
snap clamp into the open-
ing in the draft shield base,
and clip the draft shield
base to the balance. Press
the rear clip of the snap
clamp into place.
Pan and Pan Support Pan and Pan Support Pan and Pan Support Pan and Pan Support Pan and Pan Support
Square Pan Square Pan
Square Pan Square Pan
Square Pan
Insert the pan support into the hole in the
weighing mechanism as shown in the
illustration. Make sure the hole in the pan
support faces the rear of the balance.
Once installed, the pan support should
not rotate.
The pan has a guide pin which protrudes
from the bottom. Place the pan on the
support making sure the guide pin is in-
serted in the hole in the pan support.
PAN
SUPPORT
8
Position rib up
against display panel.
Snap
Clamp