Make sure the leaf vacuum is connected properly to the towing vehicle. DO NOT RAISE
THE HOIST IF THE UNIT IS NOT PROPERLY CONNECTED TO THE TOW
VEHICLE!
Survey the dumping area for overhead lines or any object that could hinder the path of the
box container when dumping. Be sure to look at the sides, rear of unit and above the box
container for any obstructions, persons or animals.
Secure the rear doors to the side of the box container.
Double-check the complete area to be sure all people, power lines or other objects are clear
of the dumping area.
Start the engine using the procedure located in the front of this manual. Set the engine
speed to approximately 1,200 RPM’s (increase if necessary).
Make sure the clutch is disengaged.
Slowly raise the body to the height needed to remove the material from the box container.
Use the body prop if the unloaded box container is left in the raised position.
OPERATION OF DUMP HOIST
1.
2.
3.
4.
5.
6.
7.
8.
RAISING THE DUMP BODY
LOWERING THE DUMP BODY
Make sure the leaf vacuum is connected properly to the towing vehicle. DO NOT RAISE
THE HOIST IF THE UNIT IS NOT PROPERLY CONNECTED TO THE TOW
VEHICLE!
Make sure all persons, tools or other objects are clear of the hoist .
Make sure body prop is down.
Set engine speed to appoximately 1,200 RPM’s and slowly lower hoist.
When the dump body lowers to approximately 12” from the bottom position the body may
stop. This is because a safety check valve is installed in the hoist hydraulic lines. The
check valve prevents the dump body from being lowered too quickly. DO NOT REMOVE
OR ALTER THIS VALVE IN ANY WAY!
If the body stops near the bottom, raise the body approximately 12” and slowly lower the
dump body to the bottom. The body must be lowered slowly the last 12” or it will not go to
the bottom position.
CAUTION
See Crysteel Truck Body Prop section for complete instructions.
1.
2.
3.
4
5.
6.
.
SCL800 HOIST
PAGE 1