Service Section
5.1 Removing Blower Housing Face
Review the safety section of this manual before attempt-
ing these procedures.
ODB COMPANY
Thoroughly read and understand the safety and
pre-operating sections of this manual before work-
ing on the unit.
figure 5.1a
Raise the dump body and secure it as described
previously in this manual, making sure the body
prop is in place.
Unbolt the 4 bolts holding the intake hose flange
assembly to the blower housing face (figure 5.1a).
and remove the hose assembly.
Remove the frame bolts (figure 5.1b)
Turn the adjusting rod bolt (figure 5.1b) counter-
clockwise to begin moving the boom frame out.
The frame has a built-in "stop" to prevent it from
moving too far out.
Once the frame is as far out as possible, secure
the blower housing face with an overhead crane
or lift to prevent the face from falling after the
bolts have been removed.
Remove the housing bolts (figure 5.1a) from the
housing face to gain access to the impeller.
Removing Blower Housing Face (refer to 5.1a and
5.1b):
1.
2.
3.
4.
5.
6.
800-446-9823
Make sure the negative battery cable is discon-
nected before opening the blower housing.
figure 5.1b
������
�����
�������
�����
����
�����
�������� ���
����
�������� ���
����
�����
�����
