OCHIAI DP-10, Руководство пользователя

Страница: 18 / 24

16 English
2. Articulating Hedge Trimmer CH-20
READ THIS FIRST
●
Modifying the hedge trimmer may make it unsafe.
Never modify your hedge trimmer, except as advised by
Manufacturer in writing. Use only Manufacturer supplied or
approved attachments and repair parts.
●
Damaged or loose parts can break off and injure the
operator or bystanders.
Always inspect your hedge trimmer before each use. Check
to be sure the throttle works smoothly and snaps to a closed
position when it is released. Never use a hedge trimmer with
a sticking throttle lever. Be sure the cutting tool is fastened in
place properly and is not cracked, bent, warped or broken.
●
Blade cover must be fitted on cutting blade when the
hedge trimmer is not in operation.
●
To reduce fire hazard keep the engine and muffler free of
debris, leaves or excessive lubricant.
●
The recoil starter rope can injure you if it is released
suddenly.
When starting the engine, grasp the recoil starter firmly by
the grip. Do not grasp the starter rope itself. Always control
the rope during rewind into the housing. Releasing the starter
rope suddenly may allow the rope to whip around and injure
you or damage the recoil starter mechanism.
●
Proper maintenance is essential for safety.
A well-maintained hedge trimmer is safer and operates more
efficiently. Regularly check hedge trimmer adjustments and
replace worn or damaged parts. If engine idle speed is set
too high, the cutting blade will not stop when the operator
releases the throttle. A worn out or damaged muffler can emit
sparks and cause a fire. Increased noise levels can lead to
hearing loss. A dull cutting blade is more likely to snag than
a sharp blade. Observe the maintenance schedule in the
Owner’s Manual.
●
Store the hedge trimmer safely to prevent fire or
equipment damage.
To avoid fuel leakage and fire hazard, always empty the fuel
tank and run the carburetor dry before storing your hedge
trimmer. Old fuel can clog the carburetor and lead to hard
starting or poor running conditions. Store your hedge trimmer
in a dry, secure location out of the reach of children. When
transporting your hedge trimmer in a vehicle, take precautions
to secure it against damage from falling over and fuel spillage.
SPECIFICATIONS
Model Articulating Hedge Trimmer CH-20
Overall dimensions Length × Width × Height mm 1,043×155×97
Weight Kg 2.6
Drive shaft assembly Bearing of shaft Metal BUSH
Drive shaft dia. mm ø 7
Drive shaft material High tensile steel
Drive shaft type Solid steel
Blades Overall length mm 525
Cutting length mm 508
Tooth pitch mm 35
Blade angle adjustable range
(angle relative to the drive shaft)
Upward : 12 degrees × 4 positions
Straight to drive shaft × 1 position
Downward : 12 degrees × 7 positions
Transmission Clutch type Dry type
Gear ratio 1:4.4
Lubrication High quality lithium grease
Vibration measurement according to EN ISO 10517 (EN ISO 22867), EN 12096: handle
Front handle ahv, eq 9.8 m/s
2
(Uncertainty, K: 0.3 m/s
2
)
Rear handle ahv, eq 8.1 m/s
2
(Uncertainty, K: 0.1 m/s
2
)
Sound measurement according to EN ISO 10517 (EN ISO 22868) ISO 4871
Measured A-weighted sound power level L
WAd
: 106 dB
Measured A-weighted emission sound pressure level,
L
pA
at the operator’s position
L
pAeq
: 95 dB (Uncertainty, K: 2 dB)
CAUTION
Information that the machine cannot be use in the potentially explosive ambient.