OCHIAI DP-10, Руководство пользователя

Страница: 9 / 24

7 English
NOTICE
Allow sufficient warm-up time to prevent engine damage
and run the engine smoothly. The engine should be
run at idle speed for a few minutes to allow it to warm
up before applying a load. This will allow oil to reach
engine parts, and allow piston clearance to reach design
specifications.
NOTE
○
If it is necessary to restart the engine, do so one minute later
after the engine has been shut off.
When restarting warmed engine
●
Set the lift up lever to the “RUNNING” position and then pull
the recoil starter grip.
Idling Speed Adjustment
●
If the cutting blade move when
the engine is running at the
idle speed, turn the idle screw
counterclockwise to decrease
the engine idle speed.
●
If the engine does not run the
idle speed, it may be changed
too low, turn the idle screw
clockwise to increase the
engine idle speed.
The stable idling speed is about 3000r/min (rpm).
Fuel Adjustment
●
The carburetor has been adjusted to the optimum fuel supply
at the factory. Don’t reset the carburetor setting.
NOTE
○
If adjustment is needed, it should be performed by your
authorized equipment dealer.
Stopping the Engine
NOTICE
Suddenly stopping engine from high-speed operation
can cause engine damage. Reduce engine speed to idle
speed for one minute before shutting engine off after
high-speed, full-load operation.
Ordinary Stop
●
Move the throttle lever on the
equipment to the fully CLOSED
(engine idle speed) position,
and the engine running at idle
speed.
●
Turn the engine switch to the
“STOP” position.
Emergency Stop
●
Turn the engine switch to the “STOP” position.
●
Release the throttle lever.
Precautions After Operation
WARNING
To avoid serious injury, do not store the unit with fuel
tank, because a fuel leak could start a fire. Allow the
engine to cool before storing in any enclosure.
NOTE
○
Before cleaning repairing or inspecting, make certain the
cutting head has stopped.
Disconnect and secure the spark plug wire away from plug to
prevent accidental starting.
●
Use only recommended
genuine replacement parts to
avoid creating a hazard and/or
voiding your warranty.
●
Store in a dry area out of the
reach of children.
CATALYTIC CONVERTER
Catalytic Converter:
This small engine is equipped with a catalytic converter in the
exhaust system to significantly reduce exhaust emissions. The
catalytic converter converts carbon monoxide and hydrocarbons
into harmless carbon dioxide and water.
The catalytic converter requires special care.
●
Use only unleaded gasoline. Never use leaded gasoline.
Leaded gasoline significantly reduces the capability of the
catalytic converter.
●
Do not use 2–stroke oil that contains Phosphorus (P), Lead
(Pb), or Sulfur (S). These elements will reduce the life and
performance of the catalytic converter.
●
Before shutting the engine off, allow it to idle for a short while.
NOTE
○
Never stop the engine during operation while running above
idle speed.
●
Shut off the engine and allow it to cool before transporting or
storing the unit.
●
Do not put the unit on dry grass or near any flammable object
unless the engine is cold or cooled down.
A
A. Idle Screw
A
B
A. Throttle Lever
B. Engine Switch