OCEM AUGIER energy DIAM4200 Series, Установка и обслуживание

Страница: 7 / 84

DIAM4200 ©2018 AUGIER SA.
6021642 DIAM4200 5 to 20KVA rev 1-8.docx I-7
II.2.2.9 FAA Multiwire remote control with 120Vac control supply ___________________________ II-43
II.2.2.10 FAA Multiwire remote control with EXTERNAL 120Vac control supply _________________ II-43
II.2.2.10.1 Inputs (120Vac only) : ______________________________________________________ II-43
II.2.2.11 Example of FAA wiring : EXTERNAL 120 Vac ____________________________________ II-44
II.2.2.12 FAA Multiwire remote control with INTERNAL 120Vac control supply __________________ II-45
II.2.2.12.1 Inputs (contacts free of voltage only) : _________________________________________ II-45
II.2.2.13 Example of FAA wiring : INTERNAL 120Vac _____________________________________ II-46
II.2.2.14 FAA Multiwire remote control outputs: __________________________________________ II-47
II.2.2.15 Wiring remote control voltage configuration ______________________________________ II-49
II.2.2.16 Operating modes for multiwire (FAA & IEC) remote control __________________________ II-50
II.2.2.17 RS485/RS422 Serial Link (Option): ____________________________________________ II-51
II.2.2.18 Ethernet link (Option): _______________________________________________________ II-53
II.2.2.19 Remote fail safe mode: ______________________________________________________ II-54
II.2.2.20 Remote priority: ____________________________________________________________ II-54
II.2.2.21 Lonworks link (Option): ______________________________________________________ II-55
II.2.2.22 4-20mA outputs (Option) _____________________________________________________ II-55
II.2.3 4-20MA LOOP CURRENT : ______________________________________________________ II-55
II.2.3.1 4-20mA current loop for output current and power measurements : ___________________ II-56
II.2.3.2 4-20mA loop current (ground insulation): ________________________________________ II-56
II.2.4 CIRCUIT SELECTOR: __________________________________________________________ II-57
II.3 ADJUSTING THE CCR _____________________________________________________________ II-58
II.3.1 PARAMETER MODIFICATION ___________________________________________________ II-58
II.3.1.1 Preferred configuration values: ________________________________________________ II-58
II.3.1.2 Brightness values: __________________________________________________________ II-59
II.3.1.3
Value of “Open Circuit” protection level: _________________________________________ II-59
II.3.1.4
Value of “Overcurrent” protection levels: _________________________________________ II-59
III COMMISSIONING __________________________________________________ III-60
III.1 PROCEDURE ___________________________________________________________________ III-60
III.2 TESTS _________________________________________________________________________ III-61
III.2.1 SHORT-CIRCUIT TESTS _______________________________________________________ III-61
III.2.2 OVERLOAD TESTS ___________________________________________________________ III-61
III.2.3 OPEN-CIRCUIT TEST _________________________________________________________ III-61
IV MAINTENANCE __________________________________________________ IV-62
IV.1 FORMALISATION ________________________________________________________________ IV-62
IV.2 PROCEDURE FOR INTERVENTION _________________________________________________ IV-62
IV.3 PREVENTIVE ___________________________________________________________________ IV-63
IV.3.1 FIRST MONTHS ______________________________________________________________ IV-63
IV.3.2 ANNUAL PROCEDURE ________________________________________________________ IV-63
IV.3.3 EVERY THREE YEARS ________________________________________________________ IV-63
IV.4 CORRECTIVE ___________________________________________________________________ IV-64
IV.4.1 FAULT DIAGNOSIS ___________________________________________________________ IV-65