DIAM4200 ©2018 AUGIER SA.
6021642 DIAM4200 5 to 20KVA rev 1-8.docx
II-33
II.2.1.3 Lighting loop:
Connection is made at the back, the cables arriving through the base, from beneath the device:
•
Connect the two load cables to the “HV1” and “HV2” terminals on the load plate (or on the Cut out plate, if
the option is present) by crimping t
he lugs (φ 8mm) onto the core of the cable (or onto the two terminals of
the FAA isolating switch if this option installed).
WARNING :
For all brass screws and bolts of that load plate ,
A TIGHTENING TORQUE RANGING BETWEEN 6.5 and 7 Nm MUST BE RESPECTED
•
Connect the cable screens (strap or braided) to the CCR ground after having crimped a lug (φ 6mm).
Diagram:
load connection
Lighting loop connection
