Oce TDS400, Краткое руководство пользователя

Страница: 28 / 95

28 Océ TDS400 Quick Reference Manual
The zoom key
Enters the zoom mode. The icon flashes. Use the browse keys
(left
,
right ) to browse the preset zoom values. Use the browse keys (up ,
down ) to adjust the zoom value with an accuracy of 1 percent.
The exposure key
enters the exposure mode. The icon flashes. Use the browse
keys to change the exposure value.
The media key
Select roll 1, roll 2 or manual feed. The equivalent icon is on.
The display
The display shows the feedback about the scan/copy job status (see table
below) in normal mode. In off-line mode it shows the off-line menu (see figure
6 on page 31 and 7 on page 32).
Status Messages
Status messages Explanations
Scanner ready The scanner is prepared to scan.
+ = add
= close
Add an original to the set and press the start key .
After the last scan of the set, remove the original and
press the start key
to close the set
.
Connecting..... There is no communication between the controller and
the printer.
Wait until the there is communication.
Scanner asleep The printer is in low power mode.
Scanner running The scanner scans.
Please wait The scanner downloads the languages.
Remove original
Press <cancel> There is an original on the table during the turn on of the
scanner.
The message appears if you pressed the ‘cancel’ key
while you scan.
Remove the original.
Press cancel
.
Original too long
Press <cancel> Use an original shorter than 15 meter.
Wrong original type
Press <cancel> This message shows when you select ‘Background
compensation’ and ‘Blueprint’ as original.
Press cancel.
Set closed You closed the copy set.
Reset scanner Turn the scanner on and off.