Installing the Driver & Software
42
STEP 2
Macintosh
®
M
a
c
int
os
h
®
Wi
re
le
ss
Netw
o
rk
9
Choose the appropriate key number and
press
OK
.
72.WLAN
WEP key
a
KEY1:
b
KEY2:
Select
ab
or OK
Enter the WEP key you wrote down in step
1
using the dial pad. You can use the
and
keys to move the cursor. For example, to
enter the letter
a
, press the
2
key on the dial
pad once. To enter the number
3
, press the
3
key on the dial pad seven times.
The letters appear in this order: lower case,
upper case, numbers and then special letters.
Press
OK
when you have entered all the
characters, then choose
1.Yes
and press
OK
to apply your settings. Go to step
12
.
Most access points and routers can store
more than one key, but they will only use
one at any time for authentication and
encryption.
10
Press
or
to
choose
TKIP
or
AES
for
Encryption Type
and press
OK
.
Enter the WPA-PSK Password you wrote down
in step
1
using the dial pad. You can use the
and
keys to move the cursor. For
example, to enter the letter
a
, press the
2
key
on the dial pad once. To enter the number
3
,
press the
3
key on your dial pad seven times.
Press
OK
when you have entered all the
characters, then choose
1.Yes
and press
OK
to apply your settings. Go to step
12
.
11
Enter the user and press
OK
. You can use
and
keys to move the cursor. For example,
to enter the letter
a
, press the
2
key on the dial
pad once.
Enter the password and press
OK
, and then
choose
1.Yes
and press
OK
to apply your
settings. Go to step
12
.
12
Your machine will now try to connect to your
wireless network using the information you
have entered. If successful,
Connected
will
appear briefly on the LCD.
Connection NG
is displayed when the print
server has not successfully connected to your
router or access point. Try starting from step
3
again. If the same message is displayed again,
reset the print server back to the default factory
settings and try again. (See
Restoring the
network settings to factory default
on page 47.)
13
The machine will automatically acquire the
correct TCP/IP address information from your
access point (router) if DHCP is enabled
(DHCP is normally enabled as default for most
access point routers).
If your access point does not have DHCP
enabled you will need to manually configure
the IP address, subnet mask and gateway of
the machine to suit your network. See the
Network User’s Guide for details.
Wireless setup is now complete. To install
the printer driver, scanner driver and
ControlCenter2, continue to step 14.
14
Turn on your Macintosh
®
.
15
Put the supplied CD-ROM into your CD-ROM
drive.
16
Double-click the
Start Here OSX
icon to install.
Follow the on-screen instructions.
Please wait, it will take a few seconds for the
software to install. After the installation, click
Restart
to finish installing the software.
