Oce ColorWave 300, Руководство пользователя

Страница: 159 / 356

Make a scan and remove a strip
Introduction
Use 'Remove strip' to scan an original with a strip and remove the strip from the scanned
file. You can remove a strip from the leading, the trailing, the left or the right side of the
original.
Before you begin
If you must enter the same value for a setting very often, you can set this value as the de-
fault value for that setting in the Océ Express WebTools.
After you press the start key, the user panel always shows the job number and status of
the job. A copy job appears temporarily in the 'Jobs - Queue' section of the Océ Express
WebTools, a scan job appears in the Smart Inbox 'Scans'.
Caution:
When you remove a strip, make sure that you scan all the required information.
How to make a scan and remove a strip
1.
Feed the original face up and centered on the original feeding table.
Note:
You do not need to center the original precisely. The exact position of the original is au-
tomatically detected by the scanner.
2.
Select 'Scan' on the user panel.
3.
Open the 'Scan' tab with the confirmation button above the scroll wheel.
4.
Define the job settings.
#
The 'Right' strip The 'Left' strip The 'Trailing' strip The 'Leading' strip
■
Open a template with the confirmation button.
■
Scroll to 'Remove strip' and open this setting with the confirmation button.
Chapter 5 - Use the Océ ColorWave 300 multifunction printer 159
Make a scan and remove a strip