Oberheim GM-400, Руководство по эксплуатации

Страница: 62 / 74

Oberheim GM 400
Digital Signal Processor
-
128
-
Allows the user to set the Midi reception channel. The OFF value cuts out reception while the
OMNI setting enables all 16 Midi channels simultaneously.
Device Id parameter. Range: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 16,
Allows the user to set the device identification number (from 1 to 16) if more than one GM 400
devices are used connected by means of Midi connectors, in order to differentiate their
reception of the System Exclusive (Sys Ex) data.
Midi Out parameter. Range: OFF, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 16.
Allows the user to set the channel for transmission of the Midi data generated by the GM 400.
The OFF value cuts out reception.
Prg parameter. Range: STD, TABLE
Sets whether or not the GM 400 is required to respond to program change messages in the
standard way or by means of the mapping which can be defined by the user, described in the
PROGRAM TABLE section.
Fc1 and Fc2 parameters. Range: Y, N (Y=yes, N=no)
Sets whether or not the foot controllers are to be active.
Filters on parameter. Range: IN, OUT.
Allows the user to select the outgoing and incoming messages to be filtered by means of the
PRG, CTRL, SYSEX and CLOCK parameters in the same video page.
Program (PRG) parameter. Range: ON, OFF.
Enables or disables reception/transmission of memory patch changes (also depending on the
value set in the FILTERS ON parameter). When the parameter is set as ON, the GM 400 is
able to respond to program changes.
Control (CTRL) parameter. Range: ON, OFF.
Enables or disables reception/transmission of continuous controls in real time (also depending
on the value set in the FILTERS ON parameter). When the parameter is set as ON, the GM
400 responds to this type of command.
Sys Ex parameter: Range, ON, OFF, ALL (ON, OFF).