NXP Semiconductors KITPF5200FRDMEVM, Руководство пользователя, Страница: 45 / 51

NXP Semiconductors
UM11723
KITPF5200FRDMEVM evaluation board
Window, click OPEN to load the TBB script file into the Script Command Window.
Note that the script file must have a “PF5200” prefix. You can also copy and paste the
script file in Section 6.5 "OTP script example" as a trial operation.
2. To execute the TBB script, click
RUN
in the bar at the bottom of the Script Command
Window.
3. When the script execution completes, the Script panel appears as shown below. The
Script Command Window displays the TBB script and Script Results Window shows
the results after execution. The FRDM-KL25Z automatically controls the TBBEN and
PWRON pins, so no further action is required on your part.
At this point, the PGOOD and RESETBMCU LEDs should be lit on the
KITPF5200FRDMEVM board, indicating that the PGOOD and RESETBMCU pins have
been released.
As a cross-check, open the Access tool and check the fields in the SW Regulators tab. If
the operation completed without problems, all fields should appear as expected.
UM11723 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2021. All rights reserved.
User manual Rev. 1 — 8 December 2021
45 / 51