NXP Semiconductors KITFS85SKTEVM, Руководство пользователя, Страница: 19 / 50

NXP Semiconductors
UM11183
KITFS85SKTEVM evaluation board
UM11183 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2019. All rights reserved.
User guide Rev. 2.0 — 20 February 2019
19 / 50
Table 14. SW2
Position Function Description
OFF WAKE1 open Wake1 pin not connected to V
SUP
ON WAKE1 closed Wake1 pin connected to V
SUP
Table 15. SW1
Position Function Description
TOP VBAT On VBAT from J1
MIDDLE VBAT Off Board not supplied
BOTTOM VBAT On VBAT from J10
4.4 Schematic, board layout and bill of materials
The schematic, board layout and bill of materials for the KITFS85SKTEVM evaluation
board are available at http://www.nxp.com/KITFS85SKTEVM .
5 Installing and configuring software and tools
This development kit uses FlexGUI software. FlexGUI software is based on Java JRE.
Preparing the Windows PC workstation consists of three steps.
1. Install the appropriate Java SE Runtime Environment (JRE).
2. Install Windows 7 FlexGUI driver.
3. Install FlexGUI software package.
5.1 Installing the Java JRE
1. Download Java JRE (Java SE Runtime Environment), available at http://
www.oracle.com/technetwork/java/javase/downloads/jre8-downloads-2133155.html
(8u162 or newer).
2. Open the installer and follow the installation instructions.
3. Following the successful installation, restart the computer.
5.2 Installing Windows 7 FlexGUI driver
On Windows 7 PCs, a virtual COM port installation is required. Install the Windows 7
FlexGUI driver using the following procedure.
Note: On Windows 10, it is not necessary to install virtual com port as Windows 10 uses
a generic COM port driver.
1. Connect the kit to the computer as described in Section 6 "Configuring the hardware
for startup"
2. On the Windows PC, open the
Device Manager
.
3. In the Device Manager window, right-click on SECON FLEX GUI SLAVE , and then
select Properties .